Spyder Tungsten Carbide Tipped Hole Saw Set (18-Piece)

Item: #364175

Model : #600938

UPC #00884835003791

$199.00

In-store price may vary from online price. Not all products available at all stores.

SALE

Caption goes here.

$199.00

In-store price may vary from online price. Not all products available at all stores.

Free Ship-to-Store

JETSONS6032 Huguenard Rd
FORT WAYNE, IN 46818 US

Estimated pickup day: 9/29/2026

Ship to Address

Spyders Tungsten Carbide-Tipped (TCT) hole saws cut more materials up to 5x faster and make up to 10x more cuts lasting longer than conventional bi-metal hole saws.
TCT hole saws drill through wood, MDF, fiber cement board, porous concrete block, plastic/PVC and more.
Use with Spyders Rapid Core Eject arbor system to remove cores without prying (drill hole, press button, pull back the hole saw, and eject the core), cut at an angle, and enlarge existing holes using two adapters on one pilot bit.
All TCT, Tarantula, and Bi-Metal hole saws fit on Spyder Rapid Core Eject arbors and pilot bits (sold separately), and on universal hole saw arbors.
Spyders TCT hole saw is the pros choice for innovation, high performance, speed, and versatility drill more holes in more materials in less time.
Not for use in hammer mode, or for drilling metal, wood with nails, harder, abrasive materials, or block/brick applications with a Mohs hardness of 6 or greater.
Always use a drill with a support handle.

Saw Diameter(s): 3/4, 7/8, 1-1/8, 1-3/8, 1-3/4, 2, 2-1/2, 2-5/8, 3, 3-5/8, 4-1/8, 4-1/2-Inch
Up to 10x more cuts and up to 5x faster than standard bi-metal hole saws
Spyders Rapid Core Eject arbor system ejects cores without prying, quickly changes diameter, cuts at an angle, and enlarges existing holes
Drill wood, MDF, plywood, fiber cement board, porous concrete block, some brick, plastic, PVC and more
Tungsten carbide tipped for extended life, clean cuts and extreme material drilling versatility
Universal thread uses Spyder arbor/pilot bits or other universal hole saw arbors
Maximum cut depth of 2-3/8-in
Not for drilling metal, wood with nails, or in block/brick applications with a Mohs hardness of 6 or greater
Always use a drill motor with a support handle in standard rotary drilling mode only
Not for use in hammer mode

Share

Similar Items